Max HN75 Bedienungsanleitung Seite 1

HN75 HIGH PRESSURE COIL NAILER INDEX 1. SAFETY INSTRUCTIONS ...42. SPECIFICATIONS & TECHNICAL DATA...

SEQUENTIAL TRIP The Sequential Trip requires the operator to hold the tool against the work before pulling the Trigger. This makes accurate fastener

DRIVING DEPTH ADJUSTMENT DIAL WARNING: ALWAYS disconnect air supply before adjustment dial. With air pressure set, drive nails into a representati

WHEN USING THE TOOL FOR STEEL PLATES WARNING: ● Carry out work based on the required Work Standards. ● If there is no specified work standard, refe

5. MAINTAIN FOR PERFORMANCE X DO NOT FIRE THE NAILER WHEN IT IS EMPTY Y USE RECOMMENDED OIL The velocite or turbine oil should be used to lubricate th

6-6 NIHONBASHI-HAKOZAKI-CHO, CHUO-KU, TOKYO, JAPAN Tel: (03) 3669-8131 Telefax : (03) 3669-7104 http://

According to the European Norm EN 792-13 theregulation is valid from 01.01.2001 that allfastener driving tools with contact actuation mustbe marked wi

1. SAFETY INSTRUCTIONS WARNING: TO AVOID SEVERE PERSONAL INJURY OR PROPERTY DAMAGE BEFORE USING THE TOOL, READ CAREFULLY AND UNDERSTAND THE FOLLOWI

8. INSPECT SCREW TIGHTNESS Loose or improperly installed screws or bolts cause accidents and tool damage when the tool is put into operation. Inspect

18. WHEN USING THE TOOL OUTSIDE OR ELEVATED PLACE When fastening roofs or similar slanted surface, start fastening at the lower part and gradually wo

2. SPECIFICATIONS 1. NAME OF PARTS Frame Cylinder Cap Contact Arm Nose Magazine Trigger Grip Exhaust Cover Trigger Lock Dial 2. TOOL

4. TECHNICAL DATA n NOISE A-weighted single-event ------ LWA, 1s, d 97.74 dB sound power level A-weighted single-event ------ LpA, 1s, d 89.82 dB emis

WARNING: 3. AIR SUPPLY AND CONNECTIONS Read section titled "SAFETY INSTRUCTIONS". DO NOT USE ANY POWER SOURCE EXCEPT AN AIR COMPRESS

4. INSTRUCTIONS FOR OPERATION Read section titled "SAFETY INSTRUCTIONS". 1. BEFORE OPERATION X Wear Safety Glasses or Goggles. Y Do no

Nail loading: Place a coil of nails over the Nail Post in the Magazine. Uncoil enough nails to reach the Feed Pawl, and place the second nail betwee