Max HS90A Bedienungsanleitung

HS90AHIGH PRESSURE FRAMING TOOLBEFORE USING THIS TOOL, STUDY THIS MANUAL TO ENSURE SAFETY WARNINGAND INSTRUCTIONS.KEEP THESE INSTRUCTIONS WITH THE TOO

REMOVING THE NAILqPush up the door latch to open the door.wRemove the nail. Note that when this is done, the feed pawl moves.eClose the door.Door latc

11Accessory punchSpring PinwRemove the Switching Lever to the direction of the arrow.Switching LeverSpring PinNOTE:When switching back CONTACT ACTUATI

1221PROCEDUREqHold the Trigger.wDepress the Contact Arm.CONTACT TRIP MODEL with ANTI-DOUBLE FIRE MECHANISMThe anti-double fire mechanism (US patent 55

13PROCEDURESEQUENTIAL TRIPThe Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. Thismakes accurate f

14DRIVING DEPTH ADJUSTMENT DIALALWAYS disconnect air supply before adjustment dial.qWith air pressure set, drive nails into a representative material

155. MAINTAIN FOR PERFORMANCEqDO NOT FIRE THE NAILER WHEN IT IS EMPTYwUSE RECOMMENDED OILThe velocite or turbine oil should be used to lubricate the t

• The content of this manual might be changed without notice for improvement.Recycled paper is used for this manual and its recyclable.PRINTED IN JAPA

2DEFINITIONS OF SIGNAL WORDSWARNING: Indicates a potentially hazardous situation which, if not avoided, couldresult in death or serious injury.CAUTION

3ENGLISHHS90AHIGH PRESSURE FRAMING TOOLINDEX1. SAFETY INSTRUCTIONS……………42. SPECIFICATIONS &TECHNICAL DATA……………………73. AIR SUPPLY AND CONNECTIONS…84

41. SAFETY INSTRUCTIONSPRECAUTIONS ON USING THE TOOL1. WEAR SAFETY GLASSES OR GOGGLESDanger to the eyes always exists due to the possibility of dust b

58. INSPECT SCREW TIGHTNESSLoose or improperly installed screws or bolts cause accidents and tool damage when the tool is putinto operation. Inspect t

618. WHEN USING THE TOOL OUTSIDE OR ELEVATED PLACEWhen fastening roofs or similar slanted surface, start fastening at the lower part and gradually wor

72. SPECIFICATIONS AND TECHNICAL DATA1. NAME OF PARTS2. TOOL SPECIFICATIONSPRODUCT NO. HS90AHEIGHT 12-3/4˝ (325 mm)WIDTH 4-1/2˝ (114 mm)LENGTH 11-3/4˝

8WHEN USING THE TOOL, BE SURE TO USE A SPECIAL AIR COMPRESSORAND AIR HOSE.In order to improve its performance, it has set its working pressure higher

94. INSTRUCTIONS FOR OPERATIONRead section titled “SAFETY INSTRUCTIONS”.1. BEFORE OPERATIONqWear Safety Glasses or Goggles.wDo not connect the air sup