Max HN50 Spezifikationen

HN50 HIGH PRESSURE COIL NAILER OPERATING and MAINTENANCE MANUAL . BEFORE USING THIS TOOL, STUDY THIS MANUAL

4. INSTRUCTIONS FOR OPERATION Read section titled “SAFETY INSTRUCTIONS”. 1. BEFORE OPERATION ① Wear Safety Glasses or Goggles. ② Do not conn

③ Nail loading: Place a coil of nails over the Nail Post in the Magazine. Uncoil enough nails to reach the Feed Pawl, and place the second nail betw

MODEL IDENTIFICATION CONTACT TRIP The common operating procedure on “Contact Trip” tools is for the operator to contact the work to actuate the trip

CONTACT FIRE OPERATION (CONTACT TRIP) For contact fire operation, hold the Trigger and depress the Contact Arm against the work surface. PROCEDURE

CONTACT TIP ALWAYS disconnect air supply before attaching / detaching the contact tip. Attach the Contact Tip on the tip of Contact Arm, when dr

WHEN USING THE CONCRETE NAILS This apparatus is exclusively designed for the concrete which was recently built. When using it, conform to the Constr

16

・ The content of this manual might be changed without notice for improvement. 6-6 NIHONBASHI-HAKOZAKI-CH

According to the European Norm EN 792-13 theregulation is valid from 01.01.2001 that allfastener driving tools with contact actuation mustbe marked wi

INDEX ENGLISH Page 3 to 15 Page DEFINITIONS OF SIGNAL WORDS WARNING: Indicates a potentially hazardous situation which, if

HN50 HIGH PRESSURE COIL NAILER INDEX 1. SAFETY INSTRUCTIONS ... 4 2. SPECIFICATIONS & TECHNICAL DATA . 7 3. AIR S

1. SAFETY INSTRUCTIONS Thinner Gasoline Gasoline Thinner TO AVOID SEVERE PERSONAL INJURY OR PROPERTY DAMAGE BEFORE USING THE TOOL, READ CAREFULLY

8. INSPECT SCREW TIGHTNESS Loose or improperly installed screws or bolts cause accidents and tool damage when the tool is put into operation. Insp

18. WHEN USING THE TOOL OUTSIDE OR ELEVATED PLACE When fastening roofs or similar slanted surface, start fastening at the lower part and graduall

2. SPECIFICATIONS AND TECHNICAL DATA 1. NAME OF PARTS ① Frame ② Cylinder Cap ③ Contact Arm ④ Nose ⑤ Magazine ⑥ Trigger ⑦ Grip ⑧ Exhaust Cover ⑨

4. TECHNICAL DATA ① NOISE A-weighted single-event sound power level ------ LWA, 1s, d 90.7 dB A-weighted single-event emission sound pressure leve

3. AIR SUPPLY AND CONNECTIONS Read section titled “ SAFETY INSTRUCTIONS ”. DO NOT USE ANY POWER SOURCE EXCEPT AN AIR COMPRESSOR The tool is desi